We are manufacturer, exporter, and supplier of Single phase brake motor. Basically Single Brake motor is the combination of brake and Single phase motor.
we are leading manufacturer, exporter, and supplier of two type of Single phase brake motor.
Fail Safe Brake When power off shaft lock:
Fail-safe brake motor in case of power supply off ensuring further to a precise stop and quick braking action, the security of sudden inter venations in case of an unintentional power supply failure (i.e. power supply black-out, equipment failure)The braking action is obtained without axial sliding of shaft and provides equal braking torque in both directions of rotations.
Normally off type brake when power supply on shaft lock:
Normally off type brake is a totally different type of break-in compare of failsafe. it works when supply on. It helps to stop the machine when need to stop. Like when need to machine or equipment in the situation of emergency.
Voltage and Frequency:
Single Phase Motor Are Supply volts 220 ± 5% 3 phase 50 Hz. ± 3%. we are also able to Supply motor in 110 volts on 50 or 60 HZ. Also.
Single phase Brake Motor is supplied in a robust, rugged cast iron frame with integral feet. On Request, we can supply motor in the aluminum body up to 100 L frame.
All single phase break Motor supply with class F insulation as the standard feature. Also, supply H on request of the customer.
Centrifugal switch is hart of Single phase motor. A centrifugally operated automatic Mechanism used in conjunction with split phase and another type of single phase induction motors. Centrifugal cutout switches will open or disconnect the starting winding when the rotor has reached a predetermined speed and reconnect it when the motor speed falls below it. Without such device, the starting winding is susceptible to rapid overheating and subsequent burnout.
Capacitor start induction run motors with high starting torques suitable for use in goods lift. Where high lord inertia and frequent starting and stopping involved Resistant start induction run the motor with moderately high starting torques ideally suited for optimum performance in lifting applications.
Shaft & Rotor:
Single phase brake motor Rotor is positive locking with Shaft key joint so that cannot move on high Full lord Torque. Shafts are made by En-8 or En-9 material. Rotors are of high-pressure E.C. Grad aluminum die-cast. Every rotor is dynamically balanced. Its make motor low amplitudes of Vibration & noise.
Single Phase Brake Motor are supplied with forward-reverse rotation Suitability. We are making it Connection easy. A customer can do it himself with a normal reverse foreword Switch.
We supply motor with Ingress protection 44 as defined in IS: 4691. Motors can be supplied with IP-54 and IP-55 on request.
Bearings & Lubrication:
Bearings are adequately lubricated with lithium-based high temp up to 150 deg. All the motors are supplied with C3 ball bearing & fully charged with lithium base grease at the time of assembly.